The hammer crusher is composed of a box body, a rotor, a hammer head, a backing liner, and a caster bar. Several rows of hanging hammer bodies are installed on the main shaft of the crusher, and pin shafts are penetrated through the pin holes on the circumference of the crusher. The hammer shaft is used to hinge the hammer between each row of hanging hammer bodies. The working surface can be replaced after the hammer is worn. There are two trapped pin holes on the top. The distance from the pin hole to the axis of rotation is different. It is used to adjust the space between the hammer and the grate.
In order to prevent platinum movement of the hammer body and the hammer, the compression hammer disk and the lock nut are used at both ends of the hammer body to be unchanged, and the two ends are supported on the rolling bearing, and the bearing screws are not changed on the casing. The main shaft and the motor are directly connected by an elastic coupling. In order to make the rotor operate smoothly, one end of the main shaft is equipped with a flywheel.
The arc-shaped discharge screen is installed under the rotor, and the two ends of the grate are installed on the beam. The grate outside the staff is pressed with a pressure plate. The direction of the grate is perpendicular to the direction of rotor movement. The grate space protrudes from the middle of the grate Partially formed, in order to facilitate the discharge of processing raw materials, the grate slits gradually increase downward, and at this time they are also skewed in the direction of rotor rotation.
......
Details can be accessed by clicking:http://www.zymining.com/blog/hammer-crusher-structure-and-working-principle/